• Standard configurations are:
       - two holes, 2 3/4" center to center, top or bottom of the sheet.
       - three holes, 4 1/4" center to center on the left side of the sheet.
• Configurations other than standard may have restrictions so consult your supplier.
• Press punching is less expensive on larger runs due to the efficiency of punching on the press as the product is being printed.

• The standard configurations are the same as for the press punching.
• There are no restrictions on non-standard punching configurations.
• Bindery punching is more expensive on longer runs due to the labor involved in being an offline operation.

Specifications needed by your supplier:

Number of holes - Diameter size of hole - Center to center measurement from hole to hole - Location

Example: 3 holes - 1/4" Dia. - 4 1/4" center to center at left

Also indicate if the holes are parallel to the depth or parallel to the width.