|
Unit sets can be almost any size you need the form to be. Size
limitation would be based on the equipment of the manufacturer. There are standard
stub widths for unit sets but since each is a separate form and does not have
to run through a special printer, they can be trimmed to non-standard widths.
|
Standard Stub Widths:
|
- 3 2/5"
- 3 1/2"
- 3 2/3"
- 4"
- 4 1/4"
- 5 1/2"
|
- 5 2/3"
- 6"
- 7"
- 7 1/3"
- 8"
- 8 1/2"
|
|
|
Standard Lengths:
|
| You can design
your form to be almost any length in order to make it functional. Manufacturers
may have some limitations when lengths exceed 13 1/2" due to equipment
capabilities. Listed below are some common lengths used on forms. The
common lengths shown below make good use of standard stock paper roll
sizes that are readily available to manufacturers. |
|
|
|
|
Note: Any standard stub width
can be trimmed to a non-standard size. Odd width trim adds to the
cost of the form because it is another step in the manufacturing process.
|
The illustrations below show just some of the common sizes that are used. There
are many size options available to you when working with unit sets.
|
Note: The stub on unit sets
can be at the top, bottom, left side or right side.
|
Back to Top
|
